Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
788
Managing IP Addresses for Routable Interfaces
Section 5.38
Managing IP Addresses for Routable Interfaces
The following sections describe how to configure and manage IP addresses for routable interfaces:
•
Section 5.38.1, “Configuring Costing for Routable Interfaces”
•
Section 5.38.2, “Viewing Statistics for Routable Interfaces”
•
Section 5.38.3, “Managing IPv4 Addresses”
•
Section 5.38.4, “Configuring IPv6 Neighbor Discovery”
•
Section 5.38.5, “Managing IPv6 Network Prefixes”
•
Section 5.38.6, “Managing IPv6 Addresses”
Section 5.38.1
Configuring Costing for Routable Interfaces
To configure the costing for a routable interface, do the following:
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
ip
»
{interface}
, where
{interface}
is the name of the routable interface. The
Routable
Interfaces
form appears.
1
Figure 906: Routable Interfaces Form
1.
Auto-Cost Bandwidth Box
3. Configure the following parameter(s) as required:
Parameter
Description
Auto-Cost Bandwidth (kbps)
Default:
10000
This value is used in auto-cost calculations for this routable logical interface in kbps.
4. Click
Commit
to save the changes or click
Revert All
to abort. A confirmation dialog box appears. Click
OK
to proceed.
5. Click
Exit Transaction
or continue making changes.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...
