Siemens RUGGEDCOM RX1510, User Manual

Page: 642 / 856

Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
610 Deleting a Link Failover Ping target
4. Configure the following parameter(s) as required:
Parameter Description
host-ip The IP address of the target host to verify the main path.
5. Click
Commit
to save the changes or click
Revert All
to abort. A confirmation dialog box appears. Click
OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.27.5.3
Deleting a Link Failover Ping target
To delete a link failover ping target, do the following:
1. Change the mode to
Edit Private or Edit Exclusive .
2. Navigate to
services
»
link-failover
»
{interface}
»
target
, where {interface} is the name of the interface.
The
Targets IP Addresses
table appears.
2 3 1
Figure 713: Targets IP Addresses Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click
Delete
next to the chosen ping target.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click
Exit Transaction
or continue making changes.
Section 5.27.6
Testing Link Failover
The link failover settings can be tested to confirm that each link failover configuration works properly. To launch
the test, specify for how long the system should operate on the backup interface, and for how long the system
should delay before starting the test. Cancelling the test returns the interfaces to their pre-test condition.
While the test is running, monitor the status of the test to observe the main and backup link status, ping test
results, state change, backup state, and backup interface information. As the test progresses, this information
changes as link failover switches from the main interface to the backup interface. For more information on the
Link Fail Over Status
form, refer to Section 5.27.2, “Viewing the Link Failover Status” .