RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Configuring Neighbor Discovery
817
NOTE
MPLS must be enabled and MPLS label bindings must be removed before enabling LDP. Refer to
Section 5.39.3, “Enabling/Disabling MPLS Routing”
Section 5.39.5.4, “Deleting a Static Label”
for further information.
4. Click
Commit
to save the changes or click
Revert All
to abort. A confirmation dialog box appears. Click
OK
to proceed.
5. Click
Exit Transaction
or continue making changes.
Section 5.39.7.7
Configuring Neighbor Discovery
To configure the LDP neighbor discovery, do the following:
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
mpls
»
ldp
»
discovery
. The
LDP Discovery Hello Configuration
form appears.
2
1
Figure 945: LDP Discovery Hello Configuration Form
1.
LDP Hello Interval Box
2.
LDP Hello Holdtime Box
3. Configure the following parameter(s) as required:
Parameter
Description
LDP Hello Interval
Default:
5
The time (in seconds) between the sending of consecutive Hello messages.
LDP Hello Holdtime
Default:
15
The time (in seconds) that a discovered LDP neighbor is remembered without receipt of
an LDP Hello message from the neighbor.
4. Click
Commit
to save the changes or click
Revert All
to abort. A confirmation dialog box appears. Click
OK
to proceed.
5. Click
Exit Transaction
or continue making changes.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...
