Siemens RUGGEDCOM RX1510, User Manual, Page: 302 / 856

Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
270 Adding an SNMP User
Figure 276: SNMP User Configuration Table
If no SNMP users have been configured, add users as needed. For more information, refer to Section 5.11.7.2,
“Adding an SNMP User” .
Section 5.11.7.2
Adding an SNMP User
To add an SNMP user, do the following:
1. Change the mode to
Edit Private or Edit Exclusive .
2. Navigate to admin » snmp » snmp-user and click <Add snmp-user> . The Key Settings form appears.
1
3
2
Figure 277: Key Settings Form
1. User SNMP Engine ID Box 2. User Name List 3. Add Button
3. Configure the following parameter(s) as required:
Parameter Description
User SNMP Engine ID
Synopsis:
A list of colon-separated hexa-decimal octets e.g. '4F:4C:41:71'. The
statement tailf:value-length can be used to restrict the number of octets. Note that using
the 'length' restriction limits the number of characters in the lexical representation.
The administratively-unique identifier for the SNMP engine; a value in the format
nn:nn:nn:nn:nn:...:nn, where nn is a 2-digit hexadecimal number. The minimum length is
5 octets. The maximum length is 32 octets. Each octet must be separated by a colon (:).
User Name The user for the SNMP key. Select a user name from the list.
4. Click
Add
to create the protocol. The
SNMPv3 User Configuration
screen appears.