Chapter 2
Using ROX II
RUGGEDCOM ROX II
User Guide
26
Tracing the Route to a Remote Host
Section 2.6.3
Tracing the Route to a Remote Host
To trace the route between the device and a remote host, do the following:
1. Select the
Tools
menu and click
Accessories
.
2. Depending on the host's IP address, click
Traceroute
if the host has an IPv4 address, or
Traceroute6
if the
host has an IPv6 address. The
Traceroute
screen appears.
9
2
1
3
4
5
7
6
8
Figure 14: Traceroute Screen
1.
Hostname Box
2.
Verbose Output Check Box
3.
Lookup Address Check Box
4.
Use ICMP Instead of UDP Check Box
5.
Trace It Button
6.
How Many Hops Box
7.
Packet Length Box
8.
Interface List
9.
Result Window
3. Under
Hostname
, type the name or IP address of the host.
4. If necessary, select
Verbose Output
to make the trace results more detailed.
5. If necessary, select
Lookup Address
to display the source IP address.
6. If necessary, select
Use ICMP Instead of UDP
to use ICMP in place of UDP.
7. Under
How Many Hops
, type the maximum number of hops to the remote host.
8. Under
Packet Length
, type the maximum length of each packet.
9. Under
Interface List
, select the interface that is connected to the remote host.
10. Click
Trace It
to start the trace.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...
