without having to reconfigure your firewalls and NAT devices to allow SCI to contact the
ZoneDirector.
This feature only needs to be enabled if ZoneDirector is inaccessible by SCI (e.g.,
ZoneDirector is behind a firewall/NAT device). Otherwise, configuration only needs to
be done on SCI.
NOTE
This feature is only compatible with SCI version 2.0 and later.
To configure SCI Management:
1.
Go to
Configure
>
System
, and expand the
Network Management
section.
2.
Enable the check box next to
Enable management by SmartCell Insight
.
3.
Enter the following information for your SCI system:
•
URL
: Enter the SCI URL (e.g., https://[SCI IP address]/pentaho/Home)
•
User Name
: Enter the SCI login user name used for ZD-SCI communications.
•
Password
: Enter the SCI login password used for ZD-SCI communications.
•
System ID
: Enter the System ID that you used for the ZD data source on the SCI
System Setup page (see
SCI User Guide
for details).
4.
Click
Apply
to save your changes.
Figure 36: Config SCI server
Enabling Management via FlexMaster
If you have a Ruckus Wireless FlexMaster server installed on the network, you can enable
FlexMaster management to centralize monitoring and administration of ZoneDirector
and other supported Ruckus Wireless devices. This version of ZoneDirector supports
the following FlexMaster-deployed tasks:
• Firmware upgrade for both ZoneDirector and the APs that report to them
Ruckus Wireless ZoneDirector™ Release 10.0 User Guide
66
Configuring System Settings
Enabling Network Management Systems
