deployed in a Smart Redundancy configuration, both of the actual IP addresses must
be used rather than the management IP address.
Creating Static Route Entries
Static routes can be created to allow ZoneDirector to reach remote networks which can
only be reached via a gateway other than default gateway. The gateway you use must
be in the same subnet as either the ZoneDirector primary IP address or the Management
IP address.
To create a static route to an additional gateway
1.
Go to
Configure
>
System
and locate the
Static Route
section.
2.
Click
Create New
to create a new static route.
3.
Enter a
Name
for this access route.
4.
Enter a
Subnet
(in the format A.B.C.D/M (where M is the netmask).
5.
Enter the
Gateway
address.
6.
Click
OK
to save your changes. You can create up to 4 static route entries.
Figure 18: Creating a static route entry
Static Route Example
As an example, in a network where the APs are connected to ZoneDirector via a cable
modem termination system, the APs are in a different subnet and not found via the
45
Ruckus Wireless ZoneDirector™ Release 10.0 User Guide
Configuring System Settings
Creating Static Route Entries
