It can also be used for Smart Redundancy -- when two redundant ZoneDirectors are
deployed, you can create a separate management interface to be shared by both devices.
Then, you only have to remember one IP address that you can log into regardless of
which ZoneDirector is the active unit. This shared management IP address must be
configured identically on both ZoneDirectors (see
46).
To enable an additional management interface:
1.
Go to
Configure
>
System
.
2.
Locate the
Management Interface
section and click the check box next to
Enable
IPv4 Management Interface
or
Enable IPv6 Management Interface
.
3.
Enter the
IP Address
,
Netmask
and
Access VLAN
information for the additional
interface. (If IPv6, enter
Prefix Length
instead of
Netmask
).
4.
(Optional) If you want to configure this management interface with a different gateway
from the gateway configured under “Device IP Settings”, select
Default gateway is
connected with this interface
, and enter the gateway IP address in the field provided.
Enable this option if you want to change the default gateway of the ZoneDirector to
be in your management subnet. Changing the default gateway to be in the
management subnet will cause all traffic to be routed via this gateway.
5.
NOTE
If the Management Interface is to be shared by two Smart Redundancy
ZoneDirectors, repeat these steps for the other ZoneDirector.
Click
Apply
to save your settings.
Figure 17: Enabling an additional management interface
NOTE
If a management interface is used for web UI management, the actual IP
address must still be used when configuring ZoneDirector as a client for a backend
RADIUS server, FlexMaster server or in any SNMP systems. If two ZoneDirectors are
Ruckus Wireless ZoneDirector™ Release 10.0 User Guide
44
Configuring System Settings
Changing the Network Addressing
