ZoneDirector default IP
address
AP default IP address
fc00::2
fc00::1
IPv6
DNS Address can be configured manually or obtained automatically by the DHCPv6
client.
NOTE
If you switch from IPv4 to IPv6, you will need to manually change a number of
settings that may have previously been configured, such as Access Control Lists (ACLs),
AAA server addresses, Syslog server, SNMP trap receiver, etc.
When IPv6 is enabled, the other fields where IP addresses are entered (such as Additional
Management Interface) automatically change to allow entry of IPv6 format addresses,
as shown in Figure 24.
Note that some features are not supported when in IPv6 mode. Specifically, internal
DHCP server, LAN rogue AP detection, DHCPv6 vendor specific options, Aeroscout
RFID tag detection, SSL certificate generation, UPnP, remote access to ZD, and L2TP
and WISPr in standalone APs are not supported when in IPv6 mode.
Figure 16: Enabling IPv6 automatically changes other fields to allow IPv6 addresses
Enabling an Additional Management Interface
The additional management interface is created for receiving and transmitting
management traffic only.
The management IP address can be configured to allow an administrator to manage
ZoneDirector from its management VLAN, thereby separating management traffic from
LWAPP traffic between the controller and the access points. The Management IP can
be reached from anywhere on the network as long as it is routable via the default Gateway
configured in
Device IP Settings
.
43
Ruckus Wireless ZoneDirector™ Release 10.0 User Guide
Configuring System Settings
Changing the Network Addressing
