General Instrument Functions
R&S
®
SMBV100B
525
User Manual 1178.4460.02 ─ 03
Figure 10-1: The principle of the signal to connector mapping
To perform the signal to connector mapping, perform the following:
1. Verify the current connector configuration and mapping and if necessary (re)define
it.
2. Configure and enable the required signal, e.g. trigger, marker, clock signal.
3. Connect the configured connector, e.g. to the external instrument or device.
For a step-by-step description:
See
Chapter 2.3.4, "Enabling and Configuring a Marker Signal"
To find out the physical location of the connector on the front/rear panel of the
instrument
Proceed as follows:
1. Select
or
to open the "Trigger Marker
Clock" and the "RF Connectors" dialog.
2. For the corresponding connector, select the "Find" icon.
The "Find Connector" dialog opens and displays the physical location of the
selected connector on the front/rear panel of the instrument.
A blinking LED on the front/rear panel indicates the selected connector, too.
See also
10.3
Organizing Frequently Used Settings as Favorites
The [
★
(User)] key is a key with customizable function. Per default, pressing the key
opens the "User Menu" but you can add or remove actions, too. You can add actions to
be executed or function to be accessed upon pressing this key.
User menu and [
★
(User)] key
These two functions work similar to the favorites function of browser or other programs.
They allow you to create a list of frequently used actions or to group frequently used
settings in one single dialog.
Organizing Frequently Used Settings as Favorites
