Rohde & Schwarz SGU100A, User Manual, Page: 62 / 236

Understanding the R&S SGMA-GUI Software
R&S
®
SGU100A
60 User Manual 1176.7726.02 ─ 09
Frequency
Sets the RF frequency at the RF output connector of the selected instrument.
Remote command:
[:SOURce]:FREQuency[:CW|FIXed]
on page 169
RF On/Off
Activates and deactivates the RF output signal.
The current state of the RF output (activated and deactivated) is indicated in the main
panel with the different block color (blue or gray) and the status "On/Off".
Remote command:
:OUTPut[:STATe]
on page 167
Mod State
Switches the I/Q modulation on and off.
Remote command:
[:SOURce]:IQ:STATe
on page 170
PEP
Displays the Peak Envelope Power (PEP) of the RF signal of the selected instrument.
The value is calculated as follows:
"PEP" = Level + Crest Factor
Remote command:
[:SOURce]:POWer:PEP?
on page 177
Level/Level Offset
Sets the RF level at the RF output connector of the selected instrument.
If you set a level offset, it will be indicated in the R&S SGMA-GUI main panel by a
change in the name of this parameter from "Level" to "Level Offset".
Note: The SCPI command
[:SOURce]:POWer[:LEVel][:IMMediate][:
AMPLitude]
sets the level of the "Level" display, that means the level containing off-
set while
[:SOURce]:POWer:POWer
sets the level at the RF output connector.
Remote command:
[:SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude]
on page 176
[:SOURce]:POWer:POWer
on page 177
6.4 Working with R&S SGMA-GUI
This section explains how to work with the R&S SGMA-GUI software and perform con-
figuration tasks for manual operation of the instruments.
Working with R&S SGMA-GUI