Rohde & Schwarz SGU100A, User Manual, Page: 16 / 236

Preparing for Use
R&S
®
SGU100A
14 User Manual 1176.7726.02 ─ 09
2 Preparing for Use
● Putting into Operation ............................................................................................. 14
● Linux Operating System ..........................................................................................20
● Connecting an External PC and Devices ................................................................20
2.1 Putting into Operation
This section describes the basic steps to be taken when setting up the R&S SGU for
the first time.
Risk of injury and instrument damage
The instrument must be used in an appropriate manner to prevent electric shock, fire,
personal injury, or damage.
●
Do not open the instrument casing.
●
Read and observe the "Basic Safety Instructions" delivered as a printed brochure
with the instrument.
In addition, read and observe the safety instructions in the following sections.
Notice that the data sheet may specify additional operating conditions.
Risk of instrument damage due to inappropriate operating conditions
Specific operating conditions are required to ensure accurate measurements and to
avoid damage to the instrument. Observe the information on appropriate operating
conditions provided in the basic safety instructions and the instrument's data sheet.
Instrument damage caused by electrostatic discharge
Electrostatic discharge (ESD) can damage the electronic components of the instrument
and the device under test (DUT). Electrostatic discharge is most likely to occur when
you connect or disconnect a DUT or test fixture to the instrument's test ports. To pre-
vent electrostatic discharge, use a wrist strap and cord and connect yourself to the
ground, or use a conductive floor mat and heel strap combination.
Putting into Operation