Rohde & Schwarz SGU100A, User Manual, Page: 170 / 236

Remote Control Commands
R&S
®
SGU100A
168 User Manual 1176.7726.02 ─ 09
Example: See Chapter 11.1.2, "Generating an I/Q Modulated Signal" ,
on page 140.
Manual operation: See "RF On/Off" on page 60
:OUTPut[:STATe]:PON <Mode>
Selects the state which the RF output takes when the instrument is switched on.
Parameters:
<Mode> OFF | UNCHanged
OFF
When the instrument is switched on, the output is deactivated .
UNCHanged
When the instrument is switched on, the output remains in the
same state as it was before the instrument was switched off.
*RST:
UNCHanged
Example: See Chapter 11.1.2, "Generating an I/Q Modulated Signal" ,
on page 140 .
Manual operation: See "Power-On State" on page 78
:OUTPut:AFIXed:RANGe:LOWer?
Queries the minimum level which can be set without the attenuator being adjusted.
Return values:
<Lower> float
Default unit: dBm
Example: See Chapter 11.1.3, "Advanced Task for Optimizing Perform-
ance" , on page 142.
Usage: Query only
Manual operation: See "Level Range" on page 77
:OUTPut:AFIXed:RANGe:UPPer?
Queries the maximum level which can be set without the attenuator being adjusted.
Return values:
<Upper> float
Default unit: dBm
Example: See Chapter 11.1.3, "Advanced Task for Optimizing Perform-
ance" , on page 142 .
Usage: Query only
Manual operation: See "Level Range" on page 77
OUTPut Subsystem