R&S
FS-K30
Measurements & Settings
Loss
Settings
Software Manual 1300.6637.42 - 03
75
DELETE
The
DELETE
softkey deletes the currently selected row in the Loss Input Table. Note
that no confirmation is required for this action.
2.7.4 Loss Settings – Loss Output Settings
The Loss Output settings are those that affect the overall use of Loss Output values
during calculations.
2.7.4.1 Selection
Selection
should be set to Constant if one Loss Output value is to be used for all
frequencies. In this case, the
Loss Output Constant
value will be used across the entire
frequency range and the Loss Output Table will be ignored.
When
Selection
is set to Table, R&S FS-K30 will use the table of Loss Output values at
the bottom right of the view to calculate the Loss Output value to be used for each specific
RF
frequency at which a measurement is performed. The
Loss Output Constant
value will
be ignored and will not be selectable.
2.7.4.2 Loss Output Constant
Loss Output Constant
is the constant Loss Output value that is to be used across the
entire frequency range.
This parameter is only available when
Selection
is set to Constant.
2.7.5 Loss Output Table
The
Loss Output Table
lists the Loss Output values for different Receive Frequency
(
RF)
values. R&S FS-K30 will interpolate between points in the list for
RF
values used
in a measurement that are not explicitly entered in the Loss Output table.
When focus is moved to the Loss Output table at the bottom right of the view, the
current parameter in the table is highlighted. Navigation through the table is possible in
all four directions using the cursor keys.
It is possible to add individual values directly into the Loss Output Table, including
insertion and deletion of
RF/Loss Output
value pairs (rows in the list). The list can
contain up to 100
RF/Loss Output
value pairs. Note that the order of
RF
values in the
list is not important.
