R&S
FS-K30
General Information
Navigation
Software Manual 1300.6637.42 - 03
28
Correcting the entry
1. Position the cursor to the right of the digit which is to be deleted using the cursor
keys
or
.
2. Press the BACK key. The digit to the left of the cursor is deleted.
3. Enter new digits. Each digit is inserted to the left of the cursor, the other digits are
shifted right.
Aborting the entry
1. Press the
ESC
key during parameter editing.
The original parameter value is restored. The new entry is deleted.
2. If a pop-up dialog is displayed, press the
ESC
key again.
The entry window is closed, the original value remains active.
1.6.6.5 Entry of an enumerated value
Once a parameter has been selected (see above), a new value for an enumerated
parameter can be entered in a number of ways. To start editing the parameter, either
press the
ENTER
key on the numeric keypad, press the rollkey or left click with the
mouse on the drop down button before following the instructions below.
When the rollkey or ENTER is pressed, a drop-down menu is displayed, which
contains all the available settings that may be selected for the parameter.
Selection of setting using cursor keys
1. Cursor
or
until obtaining the required setting.
2. Press
ENTER
on external keyboard or numeric keypad, or press rollkey to select
the desired setting of parameter.
Currently
selected setting of the parameter is highlighted blue.
Pressing ENTER
sets the new setting of the parameter immediately.
Selection of setting using rollkey
1. Rotate the rollkey until reaching the required setting.
2. Press rollkey to select setting.
Example:
Select
Mode
parameter.
Currently
selected
setting
of
the
parameter
is
highlighted
blue.
Pressing the rollkey sets the new setting of the parameter immediately.
