R&S
FS-K30
General Information
Navigation
Software Manual 1300.6637.42 - 03
27
Entry using rollkey
1. Rotate the rollkey until reaching the required value.
2. Turning the rollkey clockwise increases the value, turning it counter clockwise
decreases the value.
The application prevents the minimum and maximum values of the parameter from
being exceeded and displays an “Out of range“ message box if attempted.
N.B The rollkeys increment/decrement a parameter value in small steps.
Example:
Rotate to 200MHz
IF Frequency
200 MHz
Each change of the parameter value takes place immediately. No other keys need to
be pressed.
Entry using external keyboard
N
Enter value using number keys 0 – 9 in the same way as for using the number
keys on the numeric keypad (see above).
Terminating the entry
1. Press one of the unit keys on the numeric keypad.
The unit is entered in the parameter’s edit box and the new parameter value is set
immediately.
2. Press the
ENTER
key (on numeric keypad or external keyboard) or press the
rollkey.
The new parameter value is set immediately.
Pop-up dialogs, where used, do not close automatically. They can be closed by
pressing the ESC key.
In both cases, if the new value is not valid, then a message box is displayed and the
entered value will be replaced with a valid value. For example, when a value above the
maximum allowed is entered, then the maximum value allowed will be shown in the
entry box. The parameter will still be ready for editing so that another value can be
entered if desired.
