R&S
FS-K30
General Information
Navigation
Software Manual 1300.6637.42 - 03
31
1.6.7 Status Bar & Title Bar
1.6.7.1 Title Bar
The title bar is visible at the very top of the display when R&S FS-K30 is active and no
settings views are displayed.
Fig. 8
Title Bar
The centre of the title bar shows the name of the active application. For R&S FS-K30,
this is “NOISE & GAIN”.
On the left of the title bar, the current measurement mode (frequency list calculation
mode) is displayed.
On the right of the title bar, the calibration status of R&S FS-K30 is displayed. Note that
“CALIBRATED” means that R&S FS-K30 is calibrated and does not indicate whether
the spectrum analyzer itself is calibrated or not. The calibration status of R&S FS-K30
is only displayed when second stage correction is switched on, because the calibration
status of the option is not taken into account in measurements when the second stage
correction is switched off.
1.6.7.2 Status Bar
The main status bar is displayed at the bottom of the display, just above the hotkeys.
When a parameter in a settings view is selected, the status bar will display the
minimum and maximum, settings for the selected parameter (see Fig. 9).
MIN:<XX.XX>
MAX:<XX.XX>
Fig. 9 Status Bar
When a parameter whose value is enumerated or Boolean in type is selected in any
dialog, the status bar will show “N/A“ displayed for the minimum and maximum, since
the minimum and maximum values are “Not Applicable.”
At other times, the status bar shows the current measurement status along with
detailed information about the progress through any running measurement.
The status bar is also used to display warning and error messages to the user. In order
to highlight these messages, warning messages are displayed with a blue background
and error messages with a red background. Refer to Section 1 for a list of warning and
error messages.
