R&S
FS-K30
General Information
Limit
Line
Software Manual 1300.6637.42 - 03
35
1.9.1 Adding Limit Lines
New limit lines can be defined by pressing the
NEW
softkey from the limit line selection
softkey menu.
The
NEW
softkey allows a new limit line to be defined. After pressing the
NEW
softkey
the limit line selection view will be replaced with the limit line data view.
Fig. 13 Limit Line data view (for a new limit line)
Once the limit line data has been entered as required, press the
SAVE
softkey to save
the changes. Pressing the
ESC
hardkey will display a prompt requesting whether the
limit line data should be stored or not. Select the appropriate response with the cursor
keys or rollkey and hit
ENTER
or press the rollkey to perform the selected action.
1.9.1.1 Name
The
Name
field
allows each limit line to be uniquely identified. The name can contain
any combination of number, letters and characters.
Each limit line must have a unique name. An error message will be displayed if a new
limit line is added with the same name as an existing limit line.
Pressing the
NAME
softkey will cause the
Name
field to be selected.
