![background image](http://html2.mh-extra.com/html/quantum/scalar-i6000/scalar-i6000_installation-manual_3548686086.webp)
74
Installing a Multi-Module Library
Preparing an Existing Library to Receive an Expansion Module
To prepare an existing library to receive an expansion module, complete the following procedures:
•
Positioning the Existing Library
•
Removing the Right Side Panel from the Last Existing Module
•
•
Removing the Tensioner Bracket and Hard Stop
•
Removing the X-Axis Chain Assembly
•
Removing the LBX Terminator Board
•
Removing and Replacing the LBX Board
Positioning the Existing Library
If you must move the existing library prior to installing a new expansion module, follow the preceding steps
to locate and position the modules. For more information on location specifications, see the
Scalar i6000
Planning Guide
.
Required tools: 24 mm open-end wrench, 2.5 mm hex wrench, 3 mm hex wrench, 4 mm hex wrench
1
Verify the quantity and placement of new expansion modules.
2
Verify the following:
•
There is adequate clearance for the access and service doors.
•
The selected location the new modules is level. See
Verifying the Level of the Install Location
•
All raised floor tiles have been cut out accordingly to accommodate the power, SCSI, Fibre, and
Ethernet cables to any of the modules.
3
Verify that the existing library is level. See
Verifying Level Condition
on page 33.
4
Remove all of the service doors by opening them and then lifting them off the hinges. Set the doors
aside.
5
Open all access doors.
Note
To ensure Ethernet communication, control management blades (CMB) must
be installed in each expansion module of a multi-module configuration. If the
last expansion module does not contain FC I/O blades, a CMB is not necessary
Summary of Contents for Scalar i6000
