Scalar i6000 Installation Guide
181
The following table defines which procedures to use to complete setting up partitions and configuring a
control path for each of the possible physical connection points.
Table 7
Control Path Matrix
GUI Menu Path
Procedure References
MCB Direct
Connection
FC I/O Blade
Connection
LTO-5
Connection
Setup >
Partitions >
Configure
Step 1
Step 1
Step 1
Setup >
Connectivity >
Configure FC IO Blade
•
Configuring FC I/O Blade
Ports
•
Configuring FC Host Port
Failover
•
Enabling a Disabled
Target Port
•
Configuring Datapath
Conditioning
•
Step 2
Setup > Device
> Access
Configuring Host Access
•
•
•
•
Step 3
Setup > Device
> Access
Setup > Connectivity > Port
Configuration
Step 2
Setup >
Partitions >
Control Path
Step 2
Setup > Device
> Access >
SNW Drives
Selecting a Storage
Networking Drive
Step 3
Summary of Contents for Scalar i6000
