![background image](http://html2.mh-extra.com/html/quantum/scalar-i6000/scalar-i6000_installation-manual_3548686329.webp)
Scalar i6000 Installation Guide
317
Horizontal Alignments
The horizontal alignments graphical report shows the results for tests of horizontal alignment of tape
magazines on the drive-side and door-side across frames, and for horizontal alignment of I/E stations
across frames.
•
If the graphical report shows a failed result for the drive-side or door-side, make sure that all tape
magazines are installed properly on that side and that the calibration targets are correctly snapped
on to the magazines.
•
If the graphical report shows a failed result for the I/E station, make sure the I/E station and front
door are completely shut.
•
If running the test again still generates failed results, realign the middle X-axis rail and check the
alignment of the top and bottom X-axis rails at the location of the failure.
Figure 29
Horizontal Alignments Graphical Report
Note
This graphical report is not generated for libraries with only one frame.
Summary of Contents for Scalar i6000
