172
Configuring the Library
3
Click
Close
.
4
Setup the rules.
a. Click
Setup
→
Notification
→
System Setup
.
The
System Setup Notification
dialog box appears with the
Contact Information
tab
displayed.
The
Notification
dialog box displays the
Rules
tab.
This dialog box shows all notification recipients that are set up currently in the LMC. By default,
the only e-mail address to which the library sends e-mail notifications (severity level 1 [Failed]
issues only) is [email protected] (Quantum technical support), as shown in this
Notification
dialog box example.
5
To set up a new e-mail notification recipient, click
Create
.
Note
If you have previously saved a configuration, and you enter a configuration
change, the system asks you to perform a
Save Configuration
operation.
Note
• Even though you can remove the Quantum technical support e-mail
address so that Quantum does not receive severity level 1 notifications,
Quantum recommends that you do not remove it. Also, do not include the
Quantum technical support e-mail address for severity level 2 or 3
notifications.
• The remaining steps in this procedure guide you through setting up new
e-mail notification recipients. To delete an existing e-mail address, click
the e-mail address in the
Send Email To
column, and then click
Delete
.
Summary of Contents for Scalar i6000
