![background image](http://html2.mh-extra.com/html/quantum/scalar-i6000/scalar-i6000_installation-manual_3548686126.webp)
114
Cabling
shows which FC I/O blades must be connected to the FC drive in each of the 12 drive coordinates
in either a control module or expansion module. For information on the library’s coordinate system, see
Storage Addressing System Overview
Table 5
Cable Connection Requirements for FC Drives
FC I/O Blade Positions in the
I/O Management Unit
FC Connection on I/O Blade
Drive Coordinates
Bay 3
FC-3
1,1,1,1,1,1
Bay 3
FC-4
1,1,1,2,1,1
Bay 3
FC-5
1,1,1,3,1,1
Bay 3
FC-6
1,1,1,4,1,1
Bay 4
FC-3
1,1,1,5,1,1
Bay 4
FC-4
1,1,1,6,1,1
Bay 4
FC-5
1,1,1,7,1,1
Bay 4
FC-6
1,1,1,8,1,1
Bay 5
FC-3
1,1,1,9,1,1
Bay 5
FC-4
1,1,1,10,1,1
Bay 5
FC-5
1,1,1,11,1,1
Bay 5
FC-6
1,1,1,12,1,1
Summary of Contents for Scalar i6000
