Scalar i6000 Installation Guide
197
e. The default connection mode for both target and initiator ports is
Loop Preferred
. For target
ports, other options include
Loop
and
Point to Point
. For initiator ports, other options include
Loop
and
Loop Preferred
. Therefore, if you want to change a target port that is set to
Point-
to-Point
to initiator mode, you cannot do it until you first change the port connection type to
Loop
or
Loop Preferred
. Consult your service representative before making changes to this
setting.
4
After you finish selecting the port configuration settings, click
OK
.
5
A message appears that asks whether you want to make the change. Click
Yes
.
Proceed to
Summary of Contents for Scalar i6000
