166
Configuring the Library
Setting up IPv4 Network Configuration
After completing steps 1 through 3 of
Setting Up the Network Configuration
Network
Configuration
dialog box appears.
The following table describes the elements on the
Network Configuration
dialog box.
Note
The Network Configuration submenu only appears if you have enabled
IPv6 for the physical library.
Element
Description
In the
Host Settings
area:
DHCP
If Dynamic Host Configuration Protocol (DHCP) is enabled on your network,
select
Enable
to have DHCP automatically configure the library network
settings.
Enable
makes the
IP Address
,
Subnet Mask
, and
Default Gateway
text boxes unavailable. Select
Disable
to make the
IP Address
,
Subnet Mask
,
and
Default Gateway
text boxes available for you to manually set the library
network settings.
Library Name
The network name that you want to assign to the library.
IP Address
The IP address of the library. This text box is available only if
DHCP
is disabled.
Subnet Mask
The subnet mask. This text box is available only if
DHCP
is disabled.
Default
Gateway
The IP address of the default gateway for your portion of the Ethernet network.
This text box is available only if
DHCP
is disabled.
Summary of Contents for Scalar i6000
