Scalar i2000 Installation Guide
247
Adding an I/O Management Unit
Required tools: 7 mm socket wrench, Phillips screwdriver, ESD strap
1
Shut down the library.
For more information, see
2
Open the service door.
3
Attach the ESD strap to your wrist and to an unpainted surface inside the door.
4
Use your finger or a Phillips screwdriver to loosen the thumbscrews on the cover plate where the I/O
management unit will be installed.
5
Remove the vented cover plate from in front of the LBX board. The cover plate will be reused later in
this procedure.
Note
There must be a power chassis in the expansion module when adding an I/O
management unit.
thumbscrews
thumbscrews
Summary of Contents for Scalar i6000
