![background image](http://html2.mh-extra.com/html/quantum/scalar-i6000/scalar-i6000_installation-manual_3548686325.webp)
Scalar i6000 Installation Guide
313
Test Results
The results of all subtests are displayed on the
Verification Tests
dialog box after each individual test is
completed. See
for an explanation of test results.
Table 11
Test Results
Test Results
Explanation
PASSED
Completed the test without reported errors.
MARGINAL
Completed the test, but the system had to retry or had to skip part of the test. A
MARGINAL result is considered PASSED, but the log should be checked to see if
the marginality can be corrected.
FAILED
An error has been found and needs to be corrected. A fatal error, or an error that
causes a part of the system to become disabled, will halt the test.
INCOMPLETE
This portion of a test was incomplete due to an interruption or a portion of the test
was run (for example, no scratch tape was used so must only use existing tapes).
An incomplete will occur when the door is opened, an abort command is issued, or
when the
Robotics Enable
button is pressed.
SKIPPED
This portion of the test was skipped. The cause is that either a scratch tape was
not present or the library was not configured for the test.
WARNING
A warning is additional information about the test that the user should know. For
example, if a calibration failed, but the stored offsets are analyzed, a warning
should be posted that states that the offset check might not be accurate.
STOPPED
The test was interrupted. The log will show the result to provide a record of test
interruption.
Note
A single problem in the library can cause failed results in multiple tests. After
taking action to correct a failed result, run tests that yielded marginal or failed
results again.
Summary of Contents for Scalar i6000
