BATTERY STORAGE CENTER
OPERATING INSTRUCTIONS
(90347)
Mounting
The Battery Storage Center may be mounted to a wall (mounting hardware not
included) using the three mounting holes at the top of the Storage Center (see
illustration).
At least one mounting screw MUST be screwed into a wall stud and the other
screws should utilize heavy-duty wall anchors to prevent the Storage Center
from falling off the wall when fully loaded.
Battery Tester
The included battery tester will test all common 1.5 volt and 9 volt batteries. It
will NOT test rechargeable batteries or batteries rated at voltages other than
1.5V and 9V.
To test batteries, remove the tester from the Storage Center. Lift the hinged
contact arm and place the battery so that the negative end is in contact with
the terminal on the body of the tester, and the positive end is in contact with
the terminal on the end of the hinged arm (see illustration). Read the battery
condition from the meter. To test 9 volt batteries, touch the terminals of the 9
volt battery to the terminals on the side of the tester being sure to line up the
small terminals and the large terminals.
Flashlight
Install batteries in the included flashlight by unscrewing the end with the on/off
button and removing the battery carrier. Insert three AA alkaline batteries into
the carrier making sure that the negative end of each battery rests against the
spring in each battery slot (see illustration). Insert the battery carrier back into
the flashlight in the direction of the arrows on the outside of the carrier and
screw on the end cap.
To turn the flashlight on and off, press the rubberized switch on the end of the
flashlight.
Emergency USB Charger
The included Emergency USB Charger can be used to charge a cellphone
or smartphone during power outages or at other times when an AC outlet is
not available. The charger is powered by four AA batteries which must be
installed prior to use.
To install the batteries, open the battery door on the back of the charger.
Insert four AA alkaline batteries with their negative ends resting against the
springs in each battery slot (see illustration). Replace the battery door.
To use the Emergency USB Charger, insert the appropriate charging cable
for your phone into the USB port on the front of the charger. Please note that
some phones that use USB charging cords are not compatible with standard
USB charging ports. A standard USB to micro-USB cable is included which
will charge many common phones but your phone may require a different type
charging cable which is not included. Connect the other end of the charging
cable to your phone and switch the ON/OFF switch on the front of the charger
to the ON position. The green LED will illuminate and the phone will start
charging.
Be sure to switch the ON/OFF switch to the OFF position when finished
charging to conserve the batteries in the charger.
ONE YEAR LIMITED WARRANTY
Original Power, Inc. warrants this product to the original purchaser to be free
of defects in material and workmanship for one year after the original date
of consumer purchase. This warranty does not include damage caused by
accident or misuse. The warranty does not cover components that are subject
to normal wear. Proof of purchase is required to validate your warranty if a
claim is made.
IN NO EVENT SHALL ORIGINAL POWER, INC. BE LIABLE FOR
INCIDENTAL OR CONSEQUENTIAL DAMAGES
Some states do not allow exclusion or limitation of incidental or consequential
damages, so the above exclusion may not apply to you. This warranty gives
you specific legal rights, and you may have other rights that vary from state to
state.
If Original Power, Inc., in its sole discretion, determines that the product has
become defective within the warranty period, we will repair or replace it at our
option, provided it is returned postage prepaid to:
Original Power, Inc.
Duluth, GA 30096
http://www.powerline.com/
CALL OUR TOLL-FREE CUSTOMER SERVICE NUMBER FOR
ASSISTANCE BEFORE
RETURNING ANY PRODUCT 1-(877) 249-8504
PowerLine
®
is a registered trademark of Original Power, Inc.
*All brand names are trademarks of their respective owners and are not
owned by Original Power, Inc.
INSTRUCCIONES DE OPERACIÓN DEL
CENTRO DE ALMACENAMIENTO DE PILAS
(90347)
Montaje
El centro de almacenamiento de pilas puede montarse en una pared (no se
incluye la tornillería de montaje) usando los tres agujeros de montaje de la
parte de arriba del centro de almacenamiento (vea la ilustración).
Al menos un tornillo de montaje DEBE estar roscado en un montante de
pared y los otros tornillos deben utilizar anclajes de pared de servicio pesado
para impedir que el centro de almacenamiento se caiga de la pared cuando
esté completamente cargado.
Probador de pilas
El probador de pilas incluido probará todas las pilas comunes de 1.5 y 9
voltios. NO probará pilas recargables ni pilas para voltajes distintos de 1.5 y 9
voltios.
Para probar pilas, quite el probador del centro de almacenamiento. Levante
el brazo de contacto articulado y coloque la pila de modo que el extremo
negativo esté en contacto con el terminal en el cuerpo del probador, y el
extremo positivo esté en el contacto con el terminal en el extremo del brazo
articulado (vea la ilustración). Lea el estado de la pila del medidor. Para
probar baterías de 9 voltios, ponga los terminales de la pila de 9 voltios en
contacto con los terminales del lado del probador asegurándose de alinear
los terminales pequeños con los grandes.
Linterna
Instale pilas en la linterna incluida desenroscando el extremo con el botón de
encendido/apagado y quitando el portador de pilas. Inserte tres pilas alcalinas
AA en el portador asegurándose de que el extremo negativo de cada pila
esté apoyado contra el resorte de cada pila en la ranura de la batería (vea
la ilustración). Inserte el portador de pilas en la linterna en el sentido de las
flechas en el exterior del portador y enrosque la tapa del extremo.
Para encender y apagar la linterna, oprima el interruptor cauchutado del
extremo de la linterna.
Cargador USB de emergencia
El cargador USB de emergencia puede usarse para cargar un teléfono celular
o inteligente durante cortes de corriente o en otros momentos en que no se
disponga de una toma de CA. El cargador está alimentado por cuatro pilas
AA que deben instalarse antes de usar.
Para instalar las pilas, abra la puerta de las pilas de la parte de atrás del
cargador. Inserte cuatro pilas alcalinas AA con sus extremos negativos
apoyados contra los resortes en cada ranura de pila (vea la ilustración).
Vuelva a colocar la puerta de las pilas.
Para usar el cargador USB de emergencia, inserte el cable de carga
LOW
BUT T O
N BAT T
REPLACE
GOOD
LOW
BUT T O
N BAT T
REPLACE
GOOD
LOW
BUT T O
N BAT T
REPLACE
GOOD
LOW
BUT T O
N BAT T
REPLACE
GOOD
