Quantum DXi8500, User Manual

Page: 404 / 520

Chapter 9: DXi8500 Configuration
System
374 Quantum DXi8500 User’s Guide
Caution: If VLAN tagging is enabled for a device, DXi Advanced
Reporting is unable to collect and record statistics for
traffic moving over the VLAN device (for example,
eth1.400). Statistics are still collected for the base
device (for example, eth1.)
3 For each device, select the MTU (Maximum Transmission Unit) frame
size in the
Jumbo Frame MTU Size
drop-down box.
• 1500 MTU - The standard (STD) MTU frame size of 1,500 bytes
is used.
• 9000 MTU - The jumbo MTU frame size of 9,000 bytes is used.
4 Click Update to save the changes you made to the Interface Details
table. (Clicking Update does not yet apply the new network settings
to the DXi8500.)
Click
Undo
to revert to all current Interface Details changes to the
last update.
Configuring Interface IP Addresses
Under IP Address Configuration > IP Address Table , configure one or
more network interfaces for each port or device (physical Ethernet port
or bonded device) (see Figure 208 ):
Figure 208 Network Page: IP
Address Table
1 Click Add IP to add a network interface to a device.
Or select an interface to edit the IP address, netmask, gateway and
traffic type. (To select an interface, click the radio button next to the
interface index name, for example,
bond0:2
.)