Quantum DXi8500, User Manual

Page: 333 / 520

Chapter 9: DXi8500 Configuration
VTL
Quantum DXi8500 User’s Guide 303
Note: You must configure a host before it is available in the
Host drop-down box (see Hosts on page 305).
• Target - Select the target (port) to associate with the group.
The Backpanel Locations section displays a graphical
representation of the Fibre Channel and Ethernet ports as they
appear on the rear of the system. A dark border displays around
the currently selected target.
Note: If a target is directly connected to the DXi, only the
directly connected ports are displayed. Otherwise, all
ports are displayed.
3 (Optional) Select the Use CCL check box to use the Command and
Control LUN.
Note: The CCL (Command and Control LUN) is not used in most
environments. This option is recommended for host access
groups that contain an HP-UX host. It can also be used if
hosts that are not assigned to any host access group exist
in the SAN. The CCL is accessible to hosts only through LUN
0.
Caution: If you are not sure if you should use CCL, contact
Quantum Customer Support before you enable this
option.
4 Select the check boxes for the media changer and tape drives to add
to the host access group.
The LUN assignment displays next to the device.
5 Click Apply .
Editing a Host Access Group
Edit a host access group to change the CCL setting. You can also add or
remove virtual media changers or tape drives.
To edit a host access group:
1 Select the group and click Edit .