Quantum DXi8500, User Manual

Page: 463 / 520

Chapter 10: DXi8500 Utilities
Analyzer
Quantum DXi8500 User’s Guide 433
1 In the Target IP Address box, enter the IP address of the system to
perform network analysis with.
The target system must have NetServer enabled (see
Settings on
page 433).
2 Click Start .
The throughput result is displayed under Result From Last Run in
MB/s.
Note: It takes approximately 5 seconds to refresh the results.
Settings
The Settings page allows you to enable or disable NetServer on the
DXi8500. NetServer must be enabled on the target DXi system to
perform network analysis with the system (see Performance on
page 432).
To access the
Settings page, on the Network Analyzer page, click the
Settings
tab (see Figure 243 ).
Figure 243 Settings Page
To enable or disable NetServer on the target DXi8500:
1 Select Enable NetServer to enable NetServer.
Or select Disable NetServer to disable NetServer.