Quantum DXi8500, User Manual

Page: 411 / 520

Chapter 9: DXi8500 Configuration
System
Quantum DXi8500 User’s Guide 381
• To make sure the replication segment is used when communicating
with the target DXi, you must add a network route in the Routing
Details section on the source DXi.
In this example, you would specify the following routing details for
the replication interface on the source DXi:
• Destination - Use the subnet of the target DXi (192.168.20.0).
• Dest Netmask - Use 255.255.255.0.
• Dest Gateway - Use the IP address of the gateway
(192.168.10.1).
• In addition, to enable communication with the target DXi by means
of the gateway, you must add a second host route in the Routing
Details section on the source DXi.
In this example, you would specify a second set of routing details
for the replication interface on the source DXi:
• Destination - Use the IP address of the gateway (192.168.10.1).
• Dest Netmask - Use 255.255.255.255.
• Dest Gateway - Use the replication IP address of the source DXi
(192.168.10.100).
Figure 212 Interface Routing:
Example 3
Source DXi
192.168.10.x subnet
Replication IP:
Target DXi
192.168.10.100
IP: 192.168.20.200
Management/Data IP:
192.168.20.x subnet
192.168.10.101
Gateway IP:
192.168.10.1