PART 2: CX-Server PLC Tools
OMRON
CHAPTER 10 – Data Link Editor
CX-Server PLC Tools_ Page 105
Transferring Automatic Data Link Setup Parameters to the Startup Node
The automatic data link parameters that have been set are then sent to the connected startup node PLC. It is also
possible to read the automatic data link parameters that have been set for the PLC.
Transferring Data to the Startup Node PLC
1 Click
the
Write
button in either the Automatic Datalink (Controller Link) or the Automatic Datalink Setup
dialog box.
The following dialog box will be displayed for confirmation.
2 Click
the
Yes
button.
The set data will be transferred to the startup node PLC.
Note:
•
The data link mode (manual/automatic) and data link operation are determined by the
data link setup at the startup node. With automatic setup, it is necessary to set, for the
startup node, the data link mode (automatic) and the number of data link words in the
Automatic Datalink Setup dialog box. If these are not set correctly, the data links will
not start.
•
Before starting the data links with automatic setup, make sure that the correct
automatic data link setup parameters are set for the data link startup node. If incorrect
automatic data link setup parameters are set, it may cause the equipment to operate
unpredictably. Even when the correct parameters are set, make sure that there will be
no adverse effect on the equipment before starting or stopping the data links.
Reading Data from the Startup Node
Perform this operation to check or change settings.
1 Click
the
Read
button in either the Automatic Datalink (Controller Link) or the Automatic Datalink Setup
dialog box.
The following dialog box will be displayed for confirmation.
Summary of Contents for Sysmac WS02-CXPC1-EV3
