Omron Sysmac WS02-CXPC1-EV3, Operation Manual

Page: 161 / 390

PART 2: CX-Server PLC Tools
OMRON CHAPTER 3 – IO Table Component
CX-Server PLC Tools_ Page 19
Counters, Position Controller, Numerical Control and ASCII Units
Use the following procedure to apply unit settings to Counters, Position Controllers, Numerical Control and
ASCII units.
1, 2, 3… 1. Allocate a slot to be a Counter unit, Position Controller unit, Numerical Control unit or
ASCII unit. The Enter SIOU Details dialogue is displayed.
2. Enter valid settings for the Unit Number field, Address per Unit field, Input Words field
and Output Words field. Valid settings exclude those settings that have already been
used.
3. Select the OK pushbutton to complete the operation or the Cancel pushbutton to abort the
operation.
Additionally for Counters, Numerical Control and ASCII units, for CV-series PLCs and CS1-series PLCs, the
CIO and DM Address range need to be specified; refer to
Chapter 3 - Software Switches for further information.
Interrupt Units
Interrupt units are automatically assigned until the maximum number of units has been reached.
Sysmac-Bus Master Unit and Remote Terminals
If the Sysmac-Bus Master option is selected from the context menu, the hierarchy in the IO Table component can
be further expanded to expose the Remote Terminals and IO Terminals that form part of the SYSMAC-BUS
option. Use the following procedure to apply unit settings to Sysmac-Bus Master.
1, 2, 3… 1. Allocate a slot to be a Sysmac-Bus Master unit. The Enter RM Number dialogue is
displayed.
2. Select a unit number from the Unit Number field, either 0 or 1.
3. Select the OK pushbutton to complete the operation or the Cancel pushbutton to abort the
operation.
The Sysmac-Bus Master unit provides two types of slave units that can be applied to the slave rack in the same
manner as a normal rack:
♦
C500H Remote Terminal (RT);
♦
C200H Remote Terminal (RT).
Any units on the slave racks or other Remote IO Units connected to the master are allocated IO words according
to the slot where the master is located.
For C1000H and C2000H PLCs, Word multipliers are required to set the base address of IO Terminals on each
SYSMAC-BUS Remote Master.
SIOU/Communications Units
SIOU/Communications Units can only be set up for CV-series PLCs and CS1-series PLCs.
For CV-series PLCs SIOU/Communications Units the following Unit Setup and Software Switches setup can be
performed:
♦
Basic (Software Switches setup only);
♦
CompoBus/D Master (Software Switches setup only);
♦
Controller Link;
♦
Ethernet;
♦
Host Link;
♦
ISA Board Unit (Software Switches setup only);
♦
ME-Net (Software Switches setup only);
♦
Mini-map (Software Switches setup only);
♦
M-Net (Software Switches setup only);
♦
Motion Controller (Software Switches setup only);
♦
PC (Software Switches setup only);
♦
Syslink;