Omron E5C series, User Manual

Page: 184 / 372

5 Advanced Operations
5 - 36 E5@C Digital Temperature Controllers User’s Manual (H174)
5-13 Using the Transfer Output
A transfer output can be used on models that have a transfer output.
z
Precision and User Calibration
* For details on calibration, refer to Section 6 Parameters.
Transfer Output Signal (Initial Setting Level)
You can use the Transfer Output Signal parameter to specify whether to output a current or voltage
from the transfer output.
Terminal Arrangement
z
Transfer Output Type (Initial Setting Level)
You can use the Transfer Output Type parameter to specify any of five types of data to output.
*1 When the SP is selected, the remote SP will be output while the SP Mode parameter is set to the Remote SP
Mode.
*2 This function can be set for a Position-proportional Model, but the setting will be disabled.
*3 This function can be set for standard control or for a Position-proportional Model, but the setting will be
disabled.
*4 This parameter is displayed only for a Position-proportional Model and only when there is a potentiometer
input.
5-13-1 Transfer Output Function
Precision User calibration
±
0.3% FS Supported.*
Setting range Default
4-20
: 4 to 20mA
4-20
1-5v
: 1-5 V
Transfer output type Display Setting range
OFF (default)
off
---
Set point
*1
sp
SP lower limit to SP upper limit
Set point during SP ramp
sp-m
SP lower limit to SP upper limit
PV
pV
Input setting range lower limit to input setting range upper limit or
Scaling lower limit to scaling upper limit
MV monitor (heating)
*2 mV
−
5.0 to 105.0 (heating/cooling control: 0.0 to 105.0)
MV monitor (cooling)
*3 c-mV
0.0 to 105.0
Valve opening
*4
V-m
−
10.0 to 110.0
V
I
P
R
Q
Transfer output
V
I
Transfer output
31
33
32
E5CC
Option number: 006
E5EC/E5AC
Option number: 011, 012, 013, or 014