• If a name is input that has already been registered in the [Form Name]
pull-down list, it will be possible to edit the previous data by overwriting it.
• It will not be possible to edit “Default Plate (40 x 150)”.
• Up to 40 form names including “Default Plate (40 x 150)” can be registered.
• The printer operates using millimeter units. For this reason, even if inches
are specified in the form registration, the values will be converted to
millimeters when the printer operates.
• After changing the inch/mm units, confirm the values of the [Width] and
[Length]. There are cases where the values will be changed due to
rounding during the conversion.
• The part of the set value below the decimal point will be adjusted to match
the printer main unit specifications.
Delete: This deletes the form that has been selected using [Form Name].
[Method of Deleting a Form]
(1) Select the printing media that you wish to delete from the [Form Name] pull-down list.
(2) Confirm that the sizes shown in [Width] and [Length] match the size of the printing media
that you wish to delete, then click on [Delete].
(3) Click on [Yes] in the confirmation message that will be displayed.
It will not be possible to delete “Default Plate (40 x 150)”.
Save/Load Form Information…: This enables saving and loading of the form information
that is contained in the P-PRINTER printer driver.
If all the printing media data registered using the [Form
Settings] tab is saved in a file and then the saved file
is loaded into a different computer, the same form
information can be selected from the [Form Name] list in
the [Main] tab.
In addition, when the printer driver is deleted (uninstalled)
and then re-installed, if the previously saved form
information file is loaded it will be possible to select the
same items from the [Form Name] list as there were before
the driver was uninstalled.
3.4 Method of Using the Printer Driver
68
