The Group’s Macro Properties with the eight Macro Controls on the controller. None of the Macro Controls has been assigned
yet.
The same Group’s Macro Properties with the eight unassigned Macro Controls in the software.
Assigning a Parameter to a Macro Control
To assign Macro Controls you must use the MASCHINE software. This is done in the Macro
Properties of the Group. Each Macro Control can be assigned to one destination with the full
range of the selected parameter. Macro Controls are bipolar knobs with a range of -100 % to
+100 % (0 % is centre). You can assign all modulatable parameters in the Group Modules and
Properties as well as any modulatable parameter in any Sound inside the Group (basically
modulatable parameters are parameters controlled by a knob or a button).
Working with Groups
The Group Properties
MASCHINE MIKRO MK2 - Manual - 143
Summary of Contents for MASCHINE MIKRO MK2
Page 1: ...Manual...
