LFO Controls
Description
Phase
Defines the initial phase of the LFO waveform, expressed as a percentage.
Sync
This button is used to activate synchronization of the LFO to the tempo of your
Project. If enabled, the values on the
Speed
parameter will change into rhythmi-
cal values ranging from 16/1 (= one modulation cycle in 16 bars) to 1/32 (one
cycle in 1/32nd note).
Destination
This is where you define modulation targets for the LFO, i.e. the parameters you want this LFO
to control. The knobs adjust the amount of modulation for the following targets:
Parameter
Modulation Destination
Pitch
Tune
parameter of the
Pitch / Gate
section on page 2.
Cutoff
Cutoff
parameter of the
Filter
section (with filter types
LP2
,
HP2
,
BP2
only) on
page 3.
Drive
Drive
parameter of the
FX
section on page 3.
Pan
Pan
parameter of the Sound’s Output Properties (see
4.2.6
Page 6: Velocity Destination and Modwheel Destination
Sampler parameters – page 6 of 6: VELOCITY DESTINATION and MODWHEEL DESTINATION on the controller.
Sampler parameters – page 6 of 6: Velocity Destination and Modwheel Destination in the software.
Working with Sounds
The Sampler Module
MASCHINE MIKRO MK2 - Manual - 100
Summary of Contents for MASCHINE MIKRO MK2
Page 1: ...Manual...
