Mitel MIVOICE OFFICE 250, Installation And Administration Manual

Page: 545 / 585

Phones
517
Enabling the Alternate Keyset Menu flag allows Centrex features to be accessed more easily, using
the FLASH menu option.
Extension Number, Username, Time and Date Display
When a display phone is idle, the extension number, username, time, and date are displayed. While
on a call, in DND, or unconditionally forwarded, other displays are shown. In these circumstances,
use the following procedure to re-display the date, time, user name, and extension number for 5
seconds.
To display the date, time, username, and extension number:
Press the Special button and enter the Display Time/Date feature code (300). The date, time,
username, and extension number are displayed for 5 seconds.
Node and IP Address on Power-Up
To aid in installation and troubleshooting procedures, display phones show their phone identification
for 5 seconds when power is turned on, when the system is reset, or when the phone line cord is
first plugged in or when it is removed and replaced. The extension number and assigned user name
appear on the top line of the display and the node number and IP address appear on the bottom
line. After the 5-second identification display, the phone returns to the appropriate display, depending
on its current status.
All Transient Displays Phone Flag
The “All Transient Displays” phone flag, when enabled, allows all transient call handling displays to
appear on the phone display. If it is disabled, the
CALL TRANSFERRED TO XXXX
and
MESSAGE LEFT
FOR XXXX
transient displays do not appear.
For more information about phone flags, refer to the “Phones and Devices” chapter in the
MiVoice
Office 250 Features and Programming Guide
.
Each transient display is shown for 5 seconds before another display can take its place. Disabling
the flag allows high-traffic phones such as attendants to change displays more quickly after a
message is left by the phone user or after a call is transferred.
This option cannot be programmed by the user. It is a database-programmable flag. It is not used
for single line phones.
Transient Call Indication on Call Answer Phone Flag
This programmable flag determines if the phone user sees a call display when answering a call by
pressing a secondary extension button or by reverse transferring. If enabled, the display indicates
if the call was ringing, recalling, transferred, or holding at the other phone.
HOLD
TRANSFER
FLASH
MUTE
SYS HOLD
CNF
MORE...