Mitel MIVOICE OFFICE 250, Installation And Administration Manual, Page: 291 / 585

Installation
263
Initial 52xx/53xx Manual Phone Configuration
The following manual configuration procedure is required the first time only for each phone. All future
updates to the phone are automatic. Provided the DB Programming option is set to enable the
onboard TFTP server (refer to the
MiVoice Office 250 Features and Programming Guide
, you can
provide future phone firmware updates by upgrading system software. The method to do this is
through the Admin Session Web pages. To force a manual upgrade, you must reboot the phone
using the volume up/down buttons, as described below.
To configure the Mitel 52xx/53xx phones manually:
1. Make sure the MiVoice Office 250 is up and running, and then make sure you have done the
following (if applicable):
• Configured the Mitel 52xx/53xx phones in DB Programming (refer to the
MiVoice Office 250
Features and Programming Guide
. Also, read “Hardware Revision Identification“ on
page 265 .
If the phone is pointing to the MiVoice Office 250 and the phone has not been configured in
DB Programming, the display appears to be downloading but nothing is actually happening.
You must configure the phones in DB Programming before configuring the phone.
• See the troubleshooting section on page 261 for any phone issues.
2. While the phone is powering up, press both volume buttons and then release one of the
volume buttons.
3. Using the dialpad buttons, enter cfg (234) .
4. Configure the network information for each phone. To backspace, press star (*); to enter a period,
press (#).
a. Press
*
=YES
at the Network Parameters screen.
b. Keep pressing
#=NO
until you get to the Modify Static Values screen.
c. Press
*
=YES
at the
Modify Static Values
screen. The Static Network Parms menu appears.
d. Press the volume down button to scroll to
ICP IP Address
, and enter the MiVoice Office 250
Base Server IP address.
e. Press the volume down button to scroll to
TFTP SVR IP Address
, and enter the MiVoice Office
250 Base Server IP address.
f. Press the volume down button to scroll to
TFTP SVR Port
, and enter
69
. If left at 0, the default,
the phone will first try port 20001 and then it will try port 69.
g. Press the volume down button to scroll to
Store Changes
.
h. Press
*
=YES
to store the changes.
i. Press
*
=YES
at the Reboot Now display.
When finished, the display shows the extension information and the date and time.
NOTE
This procedure assumes the MiVoice Office 250 is up, configured, and running—this
includes the desired number of Mitel 52xx/53xx phones configured in DB Programming.