Minolta DI450, Service Manual, Page: 124 / 271

D-105
(2) Adjustment of the Reference Position of the Multi Bypass Tray
Requirement
The adjustment should be made after Registration (CD/FD).
Adjustment Procedure
1. Place a sheet of paper on the Multi Bypass Tray.
2. Call the Adjust mode to the screen.
3. Touch [Printer].
4. Touch [Registration (CD)].
5. Touch [Manual].
6. Press the Start Key to let the copier produce a test pattern.
7. Check to see if width A on the test pattern is up to the specifications. If it is outside the
specified range, perform the following adjustment steps.
Setting Instructions
If width A on the test pattern is greater than the specifications, move the Multi Bypass Tray
to the rear.
If width A on the test pattern is smaller than the specifications, move the Multi Bypass Tray
to the front.
9. Press the Start key to let the copier produce a test pattern.
10. Check to see if width A on the test pattern is up to specifications.
If the width falls outside the specified range, move the tray as necessary and check
again.
Width A on the test pattern output should fall within the
following range.
Specification
5 ± 0.5 mm
1155D154AB
lead edge
8. Loosen one screw that secures the Multi Bypass
Tray in position and move the tray as necessary.
4002D219AB