Mindray M5 Exp, Operator'S Manual

Page: 184 / 357

7-2 ECG
7.1 ECG Operation Basic Procedures
1. Connect the ECG device.
Set ECG parameters if necessary.
Turn off the power supply of the system, and connect the ECG module to the
system (For connection, please refer to “2.8 Extend Modules”)
Turn on the power supply of the system
Place the ECG electrodes on the patient’s body (as shown in the following figure)
2. Enter physio operation status:
Press ECG user-defined key (set in “[Setup] -> [System Preset] ->[Key Config]”).
Move the cursor to the menu; navigate the cursor onto [Physio] and press <Set>
or the multifunctional knob.
3. Select [ECG] to be “On”, and the heart-shaped symbol appears on the upper right
part of the screen.
4. Switch the imaging modes and display formats, and adjust relevant parameters to
optimize the image.
5. Parameter adjustment:
On the Physio page, you can adjust [Speed], [ECG Gain], [ECG Pos].
6. Freeze the images and review them. For details, please refer to “7.4 ECG Review”
7. Exit ECG mode, and remove ECG electrodes from the patient.
In ECG mode, set [ECG] to be “Off”, the ECG waveform disappears and the system
exits ECG mode.
7.2 ECG Setting
Parameter preset
Enter “[Setup] -> [Image Preset] -> Physio” to preset the ECG mode parameters.
IEC standard AHA standard
Red
Yellow
Green Black
Black
Green Red
White
Left Right
Left
Right