214657
211
Revision A
Figure 5.102: Front Draper Belt
8.
Install straps (B) onto bolts, and secure with M6 flange
nuts (A).
9.
Torque M6 flange nuts (A) to 4
–
5.6 Nm (37
–
50 lbf
∙
in).
10. Tension draper belts. Refer to
5.7.2
Draper Fingers and Guides
Replace any broken or worn fingers to maintain machine performance. Excessively worn fingers will reduce picking
efficiency, resulting in losses that far exceed the cost of new fingers.
The guides, which maintain draper tracking, are located along the outboard edge on the inside of the right draper
belt on both decks. If any guide is worn enough to cause large amounts of draper tracking/shifting, replace the
guide. Check to make sure the guides are aligned perpendicular to the direction of draper travel. Excessively worn
or misaligned guides can cause the drapers to shift and ride up on the frame causing premature draper edge wear
and draper tearing.
NOTE:
It may be necessary to remove the draper belt when replacing the fingers/guides. Refer to
or
Removing Rear Draper Belt, page 208
.
Replacing Draper Fingers
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1.
Raise the hold-down fully, and engage lift cylinder safety props.
2.
Raise the header fully, and engage the combine lift cylinder safety props.
3.
Stop the engine, and remove the key from the ignition.
Summary of Contents for PW8
