214657
213
Revision A
Figure 5.105: Draper Guide (View from Lower
Left Side of Machine)
10. Use an M6 x 30 elevator bolt (A) if guide (D) is in a
finger location, and install the finger (B)
before
installing the flange nut (C).
11. Torque flange nut (C) to 4
–
5.6 Nm (37
–
50 lbf
∙
in). Hold
the finger (B) or guide (D) to prevent turning while
tightening flange nut.
IMPORTANT:
Ensure guides (D) are perpendicular to the direction of
draper travel.
12. Rotate draper belt manually to access all the
guides (D).
13. Tighten the draper belt. Refer to
or
.
5.7.3
Draper Deck Roller Bearings
Figure 5.106: Draper Roll Bearings
Each draper deck roller is supported by two self-aligning,
non-greasable roller bearings (A). Replace the roller
bearings if they are worn or damaged.
NOTE:
Top image is the right side of header, and bottom image is
the left side of header.
Summary of Contents for PW8
