MacDon PW8, Operator'S Manual

Page: 179 / 304

214657
165
Revision A
Table 5.1 Maintenance Schedule/Record (continued)
ACTION:
ü
- Check
S
- Lubricate
▲
- Change
100 Hours
S
Clean and grease driveshaft splines
–
refer to
Cleaning Driveline Splined Shaft, page 179 .
S
Lubricate driveline slip-joint and clutch
–
refer to
5.3 Lubrication, page 167 .
S
Lubricate auger drive chain and bearing
–
refer to
5.3 Lubrication, page 167 .
ü
Check tire pressure
–
refer to 5.11.3 Inflating Tire,
page 258 .
ü
Check wheel bolt torque
–
refer to 5.11.2 Installing
Wheel, page 258 .
ü
Check loose fasteners
–
refer to 8.1 Torque
Specifications, page 273 .
ü
Check bearings and seals
–
refer to 5.7.3 Draper
Deck Roller Bearings, page 213 .
ü
Check pick-up fingers for wear
–
refer to 5.7.2
Draper Fingers and Guides, page 211 .
ü
Check height control sensor pivot points
–
refer to
4.1.2 Header Height Sensors, page 96 .
End of Season
Clean and touch-up worn paint spots
Clean header
ü
Check header for wear
5.2.2 Preseason/Annual Service
CAUTION
•
Review the operator's manual to refresh your memory on safety and operating recommendations.
•
Review all safety signs and other decals on the header and note hazard areas.
•
Ensure all shields and guards are properly installed and secured. Never alter or remove safety
equipment.
•
Make certain you understand and have practiced safe use of all controls. Know the capacity and
operating characteristics of the machine.
Perform the following at the beginning of each operating season:
1. Lubricate machine completely. Refer to 5.3 Lubrication, page 167 .
2. Perform all annual maintenance. Refer to 5.2.1 Maintenance Schedule/Record, page 164 .
MAINTENANCE AND SERVICING