MacDon PW8, Operator'S Manual

Page: 214 / 304

214657
200
Revision A
5.6.3 Replacing Auger Finger Holder
Periodically check auger for damaged or severely worn finger holders and replace if necessary.
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1. Raise the hold-down fully, and engage lift cylinder safety props.
2. Shut down the combine, and remove the key from the ignition.
Figure 5.73: Center Access Cover
3. Remove two screws (A) and remove center access
cover (B).
Figure 5.74: Left and Right Access Covers
4. Remove two screws (A) and remove right access
cover (B) if the finger holder requiring replacement is
located on the right side of the auger, or remove two
screws (C) and remove the left access cover (D) if the
finger holder is located on the left side.
MAINTENANCE AND SERVICING