214657
185
Revision A
Figure 5.36: Left Side of Header
5.
Disconnect and remove hydraulic hoses (A), (B),
and (C) from drive motors (D) and (E). Install caps onto
hose ends or wrap with plastic.
IMPORTANT:
Keep hydraulic coupler tips and connectors clean.
Allowing dirt, dust, water, or foreign material to enter the
system is the major cause of hydraulic system damage.
Do
NOT
attempt to service hydraulic systems in the
field. Precision fits require a perfectly clean connection
during overhaul.
Figure 5.37: Multicoupler on Rear of Header
6.
Remove cinch strap (A).
7.
Disconnect hoses (B) and (C) from multicoupler (D).
Figure 5.38: Bottom Beam Cover
8.
Loosen three M12 hex flange nuts (A), and remove
bottom beam cover (B).
9.
Pull hoses out of bottom beam cover (B).
Summary of Contents for PW8
