MacDon PW8, Operator'S Manual

Page: 224 / 304

214657
210
Revision A
Installing Rear Draper Belt
NOTE:
If replacing more than one belt, it may be easier to remove all the belts and assemble them on the ground before
installing on the draper.
Figure 5.99: End Draper Belt
1. Wrap new draper belt (A) around the rollers with slats
facing outwards.
IMPORTANT:
Arrow on belt must point in direction of rotation.
Figure 5.100: End Draper Belt
2. Connect draper belt (D) using M6 x 15-1/2 pronged
elevator bolts (A).
3. Attach edge protector (B) to pronged elevator bolts (A),
and secure with M6 flange nuts (C) (if installing end
belt). Do
NOT tighten.
4. Torque M6 flange nuts (C) to 4
–
5.6 Nm (37
–
50 lbf
∙
in).
Figure 5.101: Front Draper Belt
5. Install connector bars (A) onto bolts, and secure with
M6 flange nuts (B).
6. Torque M6 flange nuts (B) to 4
–
5.6 Nm (37
–
50 lbf
∙
in).
7. Install two square neck elevator bolts (C) at each strap
location.
MAINTENANCE AND SERVICING