214657
205
Revision A
Figure 5.86: Flighting Extension
3.
Place the new flighting extension (A) on the auger and
ensure that new flighting is positioned on the outboard
side of the existing flighting (B).
4.
Secure flighting extension (A) to auger using existing
hardware (C).
NOTE:
Install bolts (C) with heads facing inboard and nuts
facing outboard.
5.
Repeat for opposite side.
Figure 5.87: Access Cover
IMPORTANT:
To avoid damaging the auger, remove all loose hardware
and tools from inside the auger.
6.
Install access covers (A) using two screws (B) coated
with medium-strength threadlocker (Loctite
®
243 or
equivalent). Torque screws to 8.5 Nm (75 lbf
∙
in).
Figure 5.88: Stripper Plate Clearance
7.
Rotate the auger manually to check for interference and
to check the clearance between the auger flighting and
stripper plates (B). Ensure clearance (C) is 3
–
8 mm
(1/8
–
5/16 in.) and adjust nuts (A) if necessary. Refer to
Summary of Contents for PW8
