214657
77
Revision A
Figure 3.98: Right Stop
6.
Loosen the two bolts (A) on auger upstops (B) at the
right side of header.
7.
Slide stops (C) upwards to desired float range.
8.
Tighten bolts (A).
Figure 3.99: Left Endshield
9.
Close the left endshield (A). Refer to
.
Stripper Plate Clearance
Figure 3.100: Stripper Plates
The header is equipped with a pair of stripper plates (A)
located on either side of the center opening. The stripper
plates are designed to minimize crop carryover behind the
auger, but they require proper adjustment.
Stripper plate clearance is factory-set to 3
–
8 mm
(1/8
–
5/16 in.).
NOTE:
•
If the clearance between the flighting and stripper plates
is too large, crop has a tendency to wrap around the
auger and disrupt the crop flow into the combine.
•
If the clearance is too little, the auger flighting may
contact the stripper plates and cause excessive wear to
the flighting and stripper plates.
Summary of Contents for PW8
